S&B Ford F150 & F150 Raptor 6.2L 10-16 Cold Air Intake (Dry)

S&B Ford F150 & F150 Raptor 6.2L 10-16 Cold Air Intake (Dry) – Maximize Performance & Protect Your Engine

The S&B Ford F150 & F150 Raptor 6.2L Cold Air Intake (Dry) offers up to a 20.80% improvement in airflow compared to the stock intake, significantly boosting the performance of your Ford F150 or Raptor. This intake system is designed to protect your engine from dirt and debris while improving air intake efficiency. It comes with a fully enclosed airbox to keep the filter clean and minimize the effects of engine heat on the intake air.

The cold air intake system is equipped with a massive, highly efficient air filter that is available in Cotton Cleanable or Dry Extendable media, providing your engine with a consistent supply of clean, cool air for optimal performance.

Maximum Airflow with S&B Design

S&B has designed this cold air intake system with premium components to ensure long-lasting performance and efficiency. The signature large clear lid not only enhances the look of the system but also provides a rubber lid seal to prevent unwanted engine heat from reaching the air filter. The silicone parts, such as the air filter and couplers, are crafted from high-grade rubber, capable of withstanding temperatures up to 204°C (400°F) without cracking or tearing. This ensures the longevity of the system even under the harshest conditions.

Installation Steps for S&B Cold Air Intake (Ford F150 & Raptor 6.2L 10-16)

The S&B Cold Air Intake system is designed for easy installation, requiring minimal tools and mechanical knowledge. Follow these steps for a smooth installation process:

1. Preparation:
   • Park the vehicle on a level surface and ensure the engine is cool.
   • Disconnect the negative battery terminal to avoid electrical issues during installation.
2. Remove Factory Components:
   • Start by removing the factory air intake system, including the airbox, intake tube, and any attached sensors.
3. Install the S&B Airbox:
   • Position the S&B airbox in place, aligning it with the OEM mounting points. Secure it with the provided hardware.
4. Connect the Intake Tube:
   • Attach the S&B intake tube to the throttle body and airbox. Ensure all connections are secure and clamps are properly tightened.
5. Install the Air Filter:
   • Place the large S&B air filter inside the airbox and secure it with the provided clamp.
6. Reconnect Sensors:
   • Reconnect the MAF sensor and any other sensors that were detached during the removal of the factory intake.
7. Final Checks:
   • Reconnect the negative battery terminal and start the engine. Check for any error codes and ensure all connections are tight. Take the vehicle for a test drive to ensure optimal performance.

Technical Specifications

• Airflow Improvement: 20.80% better than stock intake
• Air Filter Media: Cotton Cleanable or Dry Extendable
• Temperature Resistance: Handles up to 204°C (400°F)
• Vehicle Compatibility: Ford F150 & F150 Raptor 6.2L (2010-2016)
• Filter Oil: 80 grams, Red
• Carb Exempt ID: D-590-30 (Street legal in all U.S. states)