Rally Bar to Suit PX2/3 Ford Ranger

THE NUDGE BAR RE-IMAGINED.

Not everyone wants a bull bar, and nudge bars are, well, ugly.  Enter the STEDI Rally Bar. Featuring a powder-coated 60mm mounting tube made out of durable 2mm stainless steel, this lightweight nudge bar can securely hold up to 30kg without any compromise.

LIKE A WELL TAILORED SUIT.

The STEDI Rally Bar is designed for a seamless fully reversible and non-intrusive install (grill dependent). The inner support system is connected to the existing fasteners behind the grill, without the need for any holes. Once installed, you can expect a higher mounting position than the factory counterpart and the optimal setup for a killer lighting combination. With slick styling and the perfect compatibility for the STEDI product range, our Rally Bar will seamlessly uphold your expectations while loudly showcasing the quintessential quality of STEDI.

SPOTLIGHTS, AERIAL OR LIGHT BAR.

The STEDI Rally Bar is a perfect match for our 60-66mm Hex Brackets. The Hex is designed to reduce excessive mounting equipment, and when combined with the Rally Bar, provides the perfect solution for hosting your ideal light combination.

The nitty
gritty.

The nudge bar re-imagined.

This simple bracket for your Ford Ranger is the perfect solution to mount a set of driving lights without compromising your Ranger, Everest, or Raptor’s original look. It was designed so that it can be installed with no modifications necessary to the vehicle, and it’s much lighter than a nudge bar or bull bar.

The STEDI Rally Bar is a perfect match for our 60-66mm Hex Brackets. The Hex is designed to reduce excessive mounting equipment, and when combined with the Rally Bar, provides the perfect solution for hosting your ideal light combination.

The STEDI Rally Bar has been designed to comply with all relevant ADR’s.

To suit Ford Ranger PX2, PX3, Raptor, and Everest vehicles. DOES NOT SUIT NEXT-GEN MODELS

The Rally bar is not designed to offer protection to your vehicle and should not be considered for this purpose. The Rally bar is designed as a platform to allow the fitting of driving lights without the need for a frontal protection system (Bullbar). The Rally bar has been designed to comply with all regulations as set out in ADR 69/ and ADR 73/.

Tech Specs

• HOLDING CAPACITY: 30kg
• MATERIAL: Stainless steel (front tube)
• THICKNESS: 2mm
• DIAMETER: 60mm
• PRODUCT WEIGHT: 5.1kg
• SHIPPING WEIGHT: 6.3kg